Electronic switch manufacturers: the use of electronic switches pay attention to matters?

An electronic switch is one of the power modules. He is also a very common one. With it, naturally, he can switch and disconnect thousands of times in a short period of time. And every time can supply the output of power supply and current. As an electronic switch manufacturer here for everyone to say its note.

　　Electronic switch manufacturersThe products here are widely used in consumer electronics, small appliances, downlights, Netcom products, beauty salons, office supplies, car products, fitness equipment, toys and other products. It can also be used in these places. Electronic switch manufacturers believe that when it is in use, we need to pay attention to the use of the first to determine whether the input and output voltage specifications are consistent with the nominal value of the power supply. Or check whether the input and output leads are connected correctly before power-on to avoid damage to user equipment. In order to ensure safe use and reduce interference, please ensure that the grounding terminal is reliably grounded. Of course, please note that frequent switching will affect its life. The working environment and the degree of load will also affect its life. The electronic switch manufacturer believes that it is also recommended to check whether the installation is firm, whether the mounting screws are in contact with the power board components, and measure the insulation resistance of the housing and input and output to avoid electric shock. Or in some multi-output power supplies, the main output is generally divided into main output and auxiliary output. In order to ensure the output load adjustment rate and output dynamics and other indicators, each channel is generally required to carry at least 10% of the load. If a secondary road is used instead of a main road, the main road must be properly faked. Please refer to the specifications of the corresponding model for details.

In addition, it should be noted that in order to avoid damage to the pressure switch device, the pressure resistance and high temperature specified in the manual must be strictly controlled, and it must be used normally within the scope specified in the manual. What you must know is that although the operation can allow pressure and temperature during startup and testing, in order not to reduce the life of the sensor,Electronic switch manufacturersRemind everyone to operate strictly in accordance with the data set by the installation range. In addition, the spare parts of the product are used to prevent damage to components in harsh environments and endanger life and property, or high and low limits out of control leading to system collapse, so spare parts are very important. Therefore, the choice of the controller range is very critical to ensure that the wrong selection of the set value will not lead to system safety hazards in unintentional or even intentional situations. Electronic switch manufacturers say that vibration, shock or temperature changes may not damage or affect the controller, but in a wet place to seal the entry point to prevent moisture from entering. It is also prohibited to alter or trim components after shipment. If a change must be made, it must first be negotiated with the UE.

The content of the above article is to introduce the matters needing attention of the electronic switch. I don't know if you understand it. If you don't know it, read it quickly. Well, today's knowledge point electronic switch manufacturers will be here first, hoping to help you.